Loki

Thanks to the new ultrasonic technology, the Ultrasonic speedo allows at last to get a reliable speed data. Forget the paddlewheel sensor wich remained bloked !

User Friendly

The ultrasonic technology allows to paint the sensor with an antifouling. So that, no parasite damages the way the sensor works. The sensor does not need any care

Accuracy
For regattas, the speed is a fundamental data which is the base of every calculation of boat performance. For this application, the sensor offers a perfect linearity and an accurate measure.

Slightering
With its "flush" installation, the ultrasonic sensor guarantees to the boat an optimal slide.

There exists two kinds of sensors:

90-60-448 - Ultrasonic speedo sensor (compatible with nke installations)

90-60-479 - Ultrasonic speedo sensor compatible (with others electronics brands with paddle-Wheel output 4.5Hz/Nd sand NMEA 0183 output (VHW)

Watertightness..............IP67

Weight......................160 gr

Size..........for thru hull fitting 1.8' and 2'


Speed datas................0.3 à 50 knot

Accuracy.......................... 1% < 20 knots

Résolution........................ 1/100ème of knot

Cable............................... shielded cable 10 meters

Running temperature...... -10 to +50°C

Typical consumption..... 35mA

Power..................... 12 Volts CC

 

 

Kaiku

Sensor : Depth (+thru hull fitting +winter plug)
Indication of depth in metres or in feet depending on your choice.

This sensor provides the depth in feet or in metres depending on your choice, based on the water surface or the keel depending on its calibration. Retractable in its through-hull, it is easily stored for wintering.

It is connected to the loch sounder interface of your TOPLINE installation.

- Sensor tightness : IP67
- 6 m cable fitted with a moulded connected.
- Weight : 700 g
- Operating temperature : -10°C to +50°C
- Storage temperature : -20°C to +60°C
- Sounder range : controlled down to 50 metres

Tuuli


Sensor : Masthead unit HR
The masthead unit HR is a high resolution sensor. It is indispensable to have a true wind data with a good accurancy.

Sensor : Carbowind HR
Measure the wind over all disturbances (1,10m above the mast) for an optimum true wind

Kompassi

Sensor : waterproof fluxgate compass
Accuracy and Effectiveness. The autocompensation curve is achieved with one single circle.

This fluxgate compass provides the magnetic heading of the boat. It is installed away from magnetic disruptions and is connected to the TOPLINE bus of your installation.
Thanks to an autocompensation curve with 10° increments, you will achieve a highly accurate heading.

This compass offers you the essential basis for the calculation of the true wind. A waterproof version is available for installation.

The sensor comes with a 6 m TOPLINE bus cable , a mounting bracket and two screws.

If the loch speedometer and the anemovane are connected, they allow the calculation and hence the display of :
- the true wind direction,
- the gain of the selected course,
- the maintenance of surface estimate,
- the heading and distance to reach a man over board.

- Power supply : 10 to 16VDC
- Consumption : 25mA
- Resolution : 1°
- Tightness : IP67
- Weight : 270 gr
- Operating temperature : -10°C to +50°C
- Storage temperature : -20°C to +60°C